Code Blue IA3100 - Page 16

Code Blue
•
259 Hedcor Street
•
Holland, MI 49423 USA
•
800.205.7186
•
www.codeblue.com
GU-145-Epage 16 of 23
IA3100
Administrator Guide
63 Off hook time – The maximum conversation time
in minutes. (00-99) Minutes
63<<Off hook time (2 digits)>>#
Default = 10
64 Silent time out & Alternate Hang up method – If
this command is enabled, the IA3100 will hang
up after hearing silence for the set number of
seconds consecutively. (05-99) Seconds
64<<silent time (2 digits)>># /
Default = 00
00 = Disabled
05-99 = 5-99 Seconds
65 User ID or ANI sends out select – This
command may be used if the Unique ID is to be
sent in place of the complete ANI. (see command
35 and 60)
65<<mode select..#/default = 0
0 = Complete ANI
1 = Unique ID only
72 Voice message repetition – This is the number
of times that the recording in command 31 is to be
repeated. (0-4)
72<<message repetitions>># /
Default = 1
73 Enable auxiliary input #1 – Auxiliary #1 performs
the same as the “Emergency” button.
73#
74 Disable auxiliary input #1 74 / Default
80 Speaker Operation (0-2) – Formally known on
the CB3100 as “Call Progress Tone Monitoring,”
this feature turns off or on the phone’s ability to
allow a user to hear the IA3100 place its call and
progress through the call sequences. Best use of
this feature is when two IA3100s are sharing one
phone line; Phone 1 is activated and then Phone
2 is activated. If this feature is “0” disabled, then
User 2 will not hear Phone 1 call.
80<<mode>># / Default = 2
0 = Speaker is disabled during
entire call.
1 = Speaker is disabled during
the placement of the call.
2 = Speaker is enabled during
the entire call.
85 Temporary disable time for auxiliary input #1
(see command
6) (00-99)
85<<disable time (2 digits)>># /
Default = 30
00-99 = 0-99 Minutes
86 Wait for dial tone – This time is the maximum
time that the IA3100 will wait for dial tone (The
phone will place the call as soon as it has veried
dial tone for four seconds ). On a standard trunk
line or ring down trunk, this time period is the time
that the phone will wait to hear the call progress
tone (This is to eliminate any dial tone that may be
present during the dialing of the ring down trunk).
(0-99) Seconds
86<<wait time>># / Default = 0
Actual time is: programmed time
+ 5 sec.
87 Wait for call progress tone – This time is the
maximum time that the IA3100 will wait for a call
progress tone after the last digit has been dialed.
(0-99 Seconds)
87<<wait time>># / Default = 0
sec.
Actual time is: programmed time
+ 5 sec.
90 Return to defaults – Returns all commands
to their defaults, including all passwords. (See
command 92)
90#
(Continued on next page)