Code Blue IA4100 - Commands During a Call

Code Blue
•
259 Hedcor Street
•
Holland, MI 49423 USA
•
800.205.7186
•
www.codeblue.com
GU-139-Tpage 24 of 33
IA4100
Administrator Guide
Programming Commands (continued)
Command Explanation Format Default
76 Upon call in answer mode 76<answer mode># 0#
NOTES: FORMAT VALUE PARAMETERS
Command 76 = Answer mode: 0 or 1
0 = automatically enters two-way audio mode without password
1 = requires audio call password or phone will disconnect
Command Explanation Format Default
77 PAS enable
77<pas>Ý<output(s)>Ý<recordings(s)># 0ÝÝ#
78 Enable UPD on call answer 78<upd># 0#
NOTES: FORMAT VALUE PARAMETERS
Command 77 = Public Address System
First Value Set, enabling PAS: 0 or 1
0 = disabled
1 = enabled
Second Value Set (outputs)
See Programming Outputs (page 10)
Third Value Set (recordings)
See Programming Messages (page 11)
Command 78 = Enable Unit Programming & Diagnostics (UPD): 0 or 1
0 = don’t send bit fault on answer menu instead of RFA
1 = send bit fault on answer menu instead of RFA
Pass Codes and Reset Programming
Command Explanation Format Default
90 Programming password
90<new pass code>Ý<new pass code>#
2583#
92 Audio call password
92<new pass code>Ý<new pass code>#
#
95 Reset audio settings
95Ý95#
96 Reset phone numbers only
96Ý96#
97 Reset recordings only
97Ý97#
98 Default all settings EXCEPT
audio, phone and recordings
98Ý98#
99 Full reset (default ALL settings)
99Ý99#
NOTES: FORMAT VALUE PARAMETERS
Command 95 = Reset audio settings
Resets the audio gain for microphone, speaker, PAS and message volume back to
default