CODELOCKS CL5000 - CYLINDER MANAGEMENT; CYLINDER REMOVAL AND BYPASS FUNCTIONS

4
REMOVAL OF FRONT-LOAD CYLINDERS TO CHANGE KEY BYPASS FUNCTION, TO REPIN CYLINDERS,
OR TO REPLACE WITH CYLINDERS BY A DIFFERENT MANUFACTURER*
1. Removehandleandcylindercover.
2. Turnkey90ºclockwiseandremovecylinderfromboss.
*If intending to use a cylinderbyadifferentmanufacturer
itisadvisabletoconfirmbeforehandthatthenewcylinder
willfittheboss.NotethattheCL5000usesa6pinscrew-
capcylinder.
A - Storeroom function
Tailpieceallowskeytoturn90ºclockwisetoenablehandleto
retractthelatch-thisisthefactoryfittedfunction.
B - Classroom function
Tailpieceallowskeytoturn90ºclockwiseandberemovedleaving
thehandleengagedinCodeFreeMode.
CodeFreeModeiscancelledbyturningkey90ºanti-clockwise.
THESE TAILPIECES WILL FIT MOST SCREW-CAP
CYLINDERS FROM OTHER MANUFACTURERS
CHANGING KEY BYPASS FUNCTIONS
2
1
CYLINDERREMOVAL
A
B