Programming Error
Battery Failure
This range of locks can be operated and managed directly via the keypad or via a compatible smartphone by
downloading the K3 Connect App.
This Getting Started guide contains the common functions to enable you to quickly program your lock.
The Basics
Master Code
The factory set Master Code is #12345678. This should be changed immediately after installation (Program 01).
The Master Code (and Sub-Master Code if set) always start with the # button.
This puts the lock in Programming Mode.
Access Methods
The lock supports a maximum of 350 Clients (users): User Codes (100), User Cards (150) and User Compatible
Phones (100).
Keypad
The lock has a 12 button, back-lit keypad which includes * and # buttons. The # button is only used for
programming. The * button is used in some Programs and with NetCodes.
Code Free
Code Free can be configured via Program 04 (refer to the Programming & Operating Instructions) or via Key-in-
Lever by changing the cylinder tailpiece (refer to Installation Instructions).
Remote Release
The lock has two sets of terminals within the front housing for remote release, labelled REM1 and REM2. REM1
is intended for push-button release where the lock will open for the normal set time.
REM2 is intended for use where the lock needs to be released for a longer period. When a switch or relay
connected to REM2 is closed, the lock will open for a period of 30 minutes after which the lock will revert to
normal operation. Refer to Installation Instructions for further information.
To Next Page
Loading...
