Precautions
To reduce the risk of injury or equipment damage, observe the following precautions
when you installthe Cognex product:
l Thisdevice requires the use of an LPS or NEC class 2 power supply (non-
PoE device) or the use of a PoE Class1 (PoE device).
l Do not connect or disconnect this device from the I/O module or 15-pin USB
adapter cable when the I/O module or adapter cable is connected to a PC.
l Route cables and wires away from high-current wiring or high-voltage
power sources to reduce the risk of damage or malfunction from the
following causes: over-voltage, line noise, electrostatic discharge (ESD),
power surges, or other irregularities in the power supply.
l Changes or modifications not expressly approved by the party responsible
for regulatory compliance could void the user’s authorityto operate the
equipment.
l Ensure that the cable bend radius begins at least six inches from the
connector. Cable shielding can be degraded or cables can be damaged or
wear out faster if a service loop or bend radius is tighter than 10X the cable
diameter.
l Thisdevice should be used in accordance with the instructions in this
manual.
l All specifications are for reference purposes only and can change without
notice.
l Thisproduct isintended for industrial use in automated manufacturing or
similar applications.
l The safety of any system incorporating thisproduct is the responsibility of
the assembler of the system.
2
To Next Page
Loading...
