Cointra CAMI 6 - Assembling the Heater

EN
60
cod. 3542C100 - Rev. 01 - 09/2022
CAMI
2.3 Assembling the heater
Before assembling the heater, make sure the water and gas connections
are properly secured, identied, and positioned.
See the dimensions and connections in section 4.2.
• Fix the plugs and hooks on the wall, in a central position vertical to the appliance, as shown in the gure below.
• Mark the position of the bottom screws
• Hang the water heater on the plugs+hooks and tighten the screws for xing the unit to the wall.
• Connect the hot and cold water exible tubes, remembering to check their tightness. To avoid circulation problems,
do not remove the cold water inlet lter.
 
 
 

 
 



g. 6 - Assembly template