Coleman 9391-251 User Manual

Pole & Hub Assembly
–Begin with the Center Hub and Canopy
Poles.
–Insert the end marked TOP into the
center hub and connect one pole at a
time to the hub. (illus1), (illus. 4)
–Add a canopy hub to the five open
ends of the center hub assembly.
(illus. 2), (illus. 4)
–Insert the clip end of Leg Connector
Poles into the Canopy Hub.
–Where the two open ends of the
Leg Connector Poles meet, insert them
into the two angled openings of the Leg
Hub. Repeat for 4 more sets. (illus. 3),
(illus. 4)
–Insert clip end of Leg Pole into
open end of Leg Hub. Disconnect the
shock-corded Leg Pole so that the
lower spiked pole is laying on the
ground. (illus. 4)
15’x15’ GEOSPORT
™
SHADE
1
2
3
4
When You Are Ready To Set Up Your
Shelter
–Select a level area clear of rocks,
branches and other hard or sharp objects.
–Do not assemble your shelter under trees.
–For easier set up, two or more people
are recommended.
ASSEMBLY PARTS
Instructions apply to Part Number 9391-251
Leg Poles (5)
Part No. 9392-2301
Leg Connector Poles (10)
Part No. 9392-2311
Leg Hub (5)
Part No. 9392-2271
Center Hub Part (1)
No. 9392-2251
Canopy Poles (5)
Part No. 9392-2321
Canopy Hub(5)
Part No. 9392-2261
Illus. 4
Partially assembled
frame with all hubs
in position
Illus. 3 Leg Hub
Partially assembled
frame locked into hub
Illus. 1
Poles inserted
into hub
Illus. 2
Canopy Hub
Center Hub
Canopy Pole
Center Hub
Canopy Hub
Leg Hub
Leg Pole
Canopy
Pole
Leg Connector Poles
Leg Connector Poles
Leg Pole
Leg Hub

Coleman 9391-251 Specifications

General

Brand	Coleman
Model	9391-251
Category	Tent
Language	English

Summary

Pole & Hub Assembly

Connect Canopy Poles to Center Hub

Insert the end marked TOP into the center hub and connect one pole at a time.

Add Canopy Hub and Connect Leg Connector Poles

Add a canopy hub to the center hub assembly and insert leg connector poles into the canopy hub.

Connect Leg Connector Poles to Leg Hub

Insert leg connector poles into the angled openings of the leg hub. Repeat for 4 more sets.

Attach Leg Poles to Leg Hub

Insert leg pole into leg hub, disconnect shock-corded pole, lay spiked pole on ground.

Attach Shelter to Frame

Drape Canopy and Position Corners

Drape the canopy over the frame and position each corner over a leg hub.

Extend Poles and Secure Frame

Extend poles, insert brass hook into pole base hole, secure frame with hook/loop closures.

Adjust Tautness and Attach Guy Lines

Adjust poles to pull shelter taut, use hook straps, and attach guy lines to fabric loops.

Important Usage and Care Information

Shelter Storage and Maintenance

Dry thoroughly, brush off dirt, do not pack stakes/poles inside. Store poles separately.

Stake Removal and Pole Storage

Remove stakes by pulling stake itself, not shelter fabric. Do not leave poles telescoped.

UV Exposure and Flame Resistance

UV rays damage material. Keep flame sources away. Shelter meets CPAI-84 flammability.