Coleman SKYDOME 9392-513 User Manual

Pole Assembly
–You will need to assemble and connect one
pole at a time to the hub.
–Do not completely assemble poles.
a) Beginning at spring-clip end of pole,
assemble all but the last shock-corded
section. The pole and one section
should curve downward. (illus. 1)
b) Locate the center top clip on the fabric
and attach it to the Hub
(illus. 1), (illus. 3)
c) Starting at the corner, Insert the
spring-clip end of the pole through the
webbing loop and then into the
pole sleeve pushing it toward the center
(illus. 1)
d) Insert the spring-clip end into one of the
hub ports until it clicks into position.
That pole will now partially stand up.
(illus. 2), (illus. 3), (illus. 4)
e) Repeat for each of the three
remaining poles (illus. 3)
13’x11’ SkyDome
™
Screenhouse
1
When You Are Ready To Set Up Your
Shelter
–Select a level area clear of rocks,
branches and other hard or sharp objects.
–Do not set up your shelter under trees.
–For easier set up, two or more people
are recommended.
–Place fabric in center of selected location
and assemble above fabric.
ASSEMBLY PARTS
Instructions apply to Part Number 9392-513
Poles (4) Part No. 9392-1071
Hub (1) Part No. 9392-2101
Illus. 3
Poles clipped into position in
the hub
Illus. 2
Poles inserted
into hub
Illus. 1
Poles inserted through
webbing loop and
pole sleeves
Hub
Pole Sleeves
Webbing
Loop
Hub clipped
to fabric

Coleman SKYDOME 9392-513 Specifications

General

Brand	Coleman
Model	SKYDOME 9392-513
Category	Tent
Language	English

Summary

Setting Up Your Shelter

Pole Assembly Instructions

Assemble Pole Sections

Assemble all but the last shock-corded section, ensuring it curves downward.

Attach Pole to Center Clip

Locate the center top clip on the fabric and attach the pole to the Hub.

Insert Pole through Webbing Loop

Insert the spring-clip end of the pole through the webbing loop and into the pole sleeve.

Connect Pole to Hub Port

Insert the spring-clip end into a hub port until it clicks, allowing the pole to stand.

Repeat Pole Assembly

Repeat the pole assembly process for the remaining three poles.

Attach Shelter to Frame

Hook Webbing Loop to Bracket

Hook the webbing loop into position over the metal bracket once poles are attached and shelter stands.

Complete Shelter Setup

Extend All Pole Sections

Fully extend each pole by straightening all shock-corded pole sections.

Insert Pin into Pole End

Insert the pin on the pin and ring system at the corner into the pole end.

Tension and Stake Shelter

Adjust poles to pull the shelter taut and stake down through fabric loops.

Attach Corner Clips

Attach corner clips to the poles.

Attach and Stake Guy Lines

Attach guy lines to fabric loops at corners and stake them out.

Important Shelter Care and Safety