7
CAUTION
Side burner flame may be dicult to see on a bright sunny day.
CAUTION
If side burner fails to light immediately, turn burner control knobs “OFF” and wait 5 minutes before
re-lighting with a match.
Match lighting the Side Stove / Sear Stove
(if applicable)
1. Open the side burner lid.
2. Check that the side burner valve is turned “OFF”.
3. Turn the LP tank valve ON slowly (turn counter clockwise).
Wait for pressure to stabilize for 5 seconds.
4. Put match in a match holder and strike match.
5. Push down and turn the side burner control valve to “MAX” (
).
6. Hold match holder and lit match near the left side of side burner.
CAUTION
If ignition does NOT occur in 5 seconds, turn the burner controls “OFF”, wait 5 minutes
and repeat the lighting procedure. If the burner does not ignite with the valve open, gas
will continue to flow out of the burner and could accidentally ignite with risk of injury. Turn
controls and gas source “OFF” when not in use.
ATTENTION
Always preheat barbecue before starting to cook. Light all burners and adjust them to the “MAX”
position for 5 to 10 minutes with the lid closed. Following preheat; adjust the controls to medium
setting for most cooking requirements.
To EXTINGUISH
1. Push in and turn each burner control knob clockwise to the “OFF” position.
2. Turn o the LP Cylinder valve by turning the hand wheel in a clockwise direction until it stops.
WARNING
If the heat output is too low, the “Flow Limiting Device” may have been activated by a gas leak or
improper lighting procedure. If so, turn “OFF” the burner valve and cylinder valve, and perform
a “Leak Test”. If there are no leaks, perform a complete regulator Flow Limiting Device reset.
To Next Page
Loading...
Need help?
General
