2.1.2 Clamping the outboard motor
1. Tighten the transom clamp screw evenly and securely. Occasionally check the clamp screws for
tightness during operation of the outboard motor because they could become loose due to engine
vibration.
WARNING:
Loose clamp screws could allow the outboard motor to fall off or move on the transom. This
could cause loss of control. Make sure the clamp screws are tightened securely. Occasionally check
the screws for tightness during operation.
2. If the engine restraint cable attachment is equipped
on your engine, an engine restraint cable or chain
should be used. Attach to a secure mounting point
on the boat to avoid the engine being completely
lost if it accidentally falls off the transom.
8
To Next Page
Loading...
