2. Pour a small amount of suitable solvent into the tank. Install the cap and shake the tank. Drain the
solvent completely.
3. Pull the fuel joint assembly out of the tank.
4. Clean the filter in a suitable cleaning solvent and allow it to dry.
5. Replace the gasket with a new one. Reinstall the fuel joint assembly and tighten the screws firmly.
3.11 Checking and replacing anode(s)
Inspect the external anodes periodically. Remove scales from the surfaces of the anodes. Consult a
dealer for replacement of external anodes.
CAUTION:
Do not paint anodes, as this would render them ineffective and can cause more rapid engine
corrosion.
39
To Next Page
Loading...
