5
Before You Go
UNPACKING THE PRODUCT.
Unpack your new water heater from the carton and make sure that all of the parts are included. If you find that one of the components is missing, please
contact Coleman for a replacement: 1-800-224-350. Make sure to remove the protective film on the display panel on the front of the heater before use.
5-Gallon Collapsible Water
Carrier
12 Volt Auto Recharger Cord
(Located in storage compartment
of the appliance)
240 Volt Household Recharger
Cord (available on Elite version only,
located in storage compartment)
Pump Assembly Shower Hose Mesh Hose Carrybag
Shower
(varies by model)
Shower Arm
CHARGING THE BATTERY
1. Charge the battery before using your water heater for the first time.
2. Turn the main power switch to “OFF” position (available on Elite
version only)
3. (Fig. 1) Remove the rubber flap covering the charging port.
4. Plug either 12 Volt Auto Recharger Cord or 240 Volt Household
Recharger Cord into unit and the power source.
5. See indicator chart for battery status / charging status.
NOTE: Please charge the battery for 6 hours at the first time to
maximize the performance of the battery.
CLEANING THE PRODUCT
Clean before first use. It is strongly recommended that you clean the heater prior to using for the first time. Follow the simple steps on page 7 before you leave
home, and then clean at least once a year or when the hose becomes discolored with a white calcium build up.
To Set Up
Select a level, sturdy surface for your water heater. A picnic table or camp table is ideal. Do not
operate Hot Water on Demand
TM
unit from a position directly on the ground. (This allows water to drain,
preventing damage while the unit is off in freezing temperatures.)
Fill the 5-gallon collapsible water container with water. The product may use water from a lake or
stream, but make sure that there’s no debris or sand in the water, which may clog the water system
and damage the product. It’s recommended to use a piece of cloth
as filter to cover the opening of the water carrier before filling in
water.
SHOWER HEAD CONNECTION (FIG. 2)
•Shower end: threaded connector
Screw the threaded connector on the shower hose onto the end of
the shower.
•Heater end: sleeved connector
A - Pull up & hold the sleeve on the connector.
B & C - While holding the sleeve, push the connector into water outlet until it
stops.
D - Release the sleeve and the connector is locked.
IMPORTANT: To unplug the shower hose from the heater, pull up the sleeve to unlock
first, while holding the sleeve, pull out the connector.
A B
C
D
Fig. 2
THIS SIDE UP
Fig. 1
OFF
1
2
To Next Page
Loading...
Need help?
General
