Pole Assembly
–You will need to assemble and connect one
pole at a time to the hub.
–Do not completely assemble poles.
a) Beginning at spring-clip end of pole,
assemble all but the last shock-corded
section. The pole and one section
should curve downward. (illus. 2)
b) Insert the spring-clip end into one of the
hub ports until it clicks into position.
(illus. 1), (illus. 2)
c. Repeat for each of the three remaining
poles (illus. 2)
11’x9’ Insta-Clip Screen House
1
When You Are Ready To Set Up Your
Shelter
–Select a level area clear of rocks,
branches and other hard or sharp objects.
–Do not set up your shelter under trees.
–For easier set up, two or more people
are recommended.
–Place fabric in center of selected location
and assemble above fabric.
ASSEMBLY PARTS
Instructions apply to Part Number 9392-119
Poles (4) Part No. 9392-1081
Hub (1) Part No. 9392-1071
Illus. 2
Screen House laid out in position
with partially assembled frame
locked into hub.
Illus. 1
Poles inserted
into hub
Hub
Hub
Frame Clips
To Next Page
Need help?
General
