Coleman HIGHLINE 2000001091 User Manual

STITCH LINE
HIGHLINE
TM
TENT 12’ X 12’ MODEL 2000001091
Before you begin
Read all instructions before set up.
• Select a level campsite clear of rocks, branches, and other hard
or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees.
• For best results in windy conditions, position end of tent into
the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.
To Set Up Tent
1. Unfold tent and spread out on a clean, level surface with
the door facing the desired direction. (Fig. 1)
2. Assemble all poles by interlocking the shock-corded,
sections together. (See components section above for
list of poles.)
3. Insert gray main poles through the sleeves on both
sides of tent; then insert black main poles through
sleeves, in front and back of tent. Make sure black poles
overlap the gray poles. (Fig. 1)
4. Insert end of each black & gray main pole into pins .
(Fig. 2 & 2A)
5. Go to opposite end of each pole and gradually apply
pressure to each forming arches. Insert the pin into each
pole end at the sides and corners of tent. (Fig. 2 & 2A)
6. Attach frame clips along edges of tent to the black &
gray main poles. (Fig. 2B)
7. Stretch tent until taut, then secure metal loops located
on both sides and corners of tent with stakes. (Fig. 2C)
Parts and Components
Description Part Number
Main Poles, Black (2) 5010000433
Main Poles, Gray (2) 5010000506
Vestibule Pole, Long, Thin, Black (1) 5010000507
Rainfly Ridge Pole, Thin, Black w/ Metal Tips (1) 5010000434
Rear Awning Pole (1) 5010000508
Rainfly 5010000435
To Attach Rainfly
1. Insert rainfly ridge pole with metal tips through sleeve
in underside of rainfly. (Fig. 3)
2. Drape rainfly over tent with rainfly ridge pole centered
from above front door to back of tent & the green
vestibule flaps located in the front. (Fig 4).
3. Insert rainfly ridge pole into metal grommet on front of
tent, apply pressure until pole forms an arch, then
insert other end into back grommet. (Fig. 4 & 4A).
NOTE: Because of the position of the center
grommets, it may be necessary to gently pull to
on the front & back arches for easier access.
4. Insert vestibule pole through sleeve in rainfly at front
of tent. (Fig. 4)
5. Locate all hook & loop fasteners on underside of
rainfly and wrap around black and gray poles to secure.
(Fig. 5)
6. Stretch elastic straps and hook clip on each to the
metal loops at the four corners of the tent. (Fig. 6)
Fig. 3
(continued on other side)
Fig. 1
Door
Gray, Main Poles
Side Sleeve
Fig. 2
Rainfly
Sleeve in Rainfly
Fig. 4
Metal Tip
Green Vestibule Flaps
2A
2B
Door
Thin, Black,
Rainfly
Ridge Pole
Black,longer,
Main Poles
Side Sleeve
Front & Back
Sleeves
4A
Door
Fig. 5 Fig. 6
2C
Sleeve in
Rainfly
Vestibule
Pole

Coleman HIGHLINE 2000001091 Specifications

General

Brand	Coleman
Model	HIGHLINE 2000001091
Category	Tent
Language	English

Summary

Tent Setup Instructions

Unfold and Spread Tent

Unfold tent on a clean, level surface facing the desired direction.

Assemble Tent Poles

Interlock shock-corded pole sections together for tent assembly.

Insert Main Poles

Insert gray main poles through side sleeves and black poles through front/back sleeves.

Secure Poles to Pins

Insert ends of black & gray main poles into pins and apply pressure to form arches.

Attach Frame Clips

Attach frame clips along tent edges to the black & gray main poles.

Stake Tent

Stretch tent taut and secure metal loops at corners with stakes.

Rainfly Attachment

Insert Rainfly Ridge Pole

Insert the rainfly ridge pole with metal tips through the sleeve in the rainfly underside.

Drape and Center Rainfly

Drape rainfly over tent, centering the ridge pole above the front door to the back.

Secure Rainfly Ridge Pole

Insert rainfly ridge pole into front and back metal grommets, forming an arch.

Insert Vestibule Pole

Insert vestibule pole through sleeve in the rainfly at the front of the tent.

Secure Rainfly with Fasteners

Wrap hook & loop fasteners on rainfly underside around poles to secure.

Attach Vestibule Flaps

Extend out vestibule flaps and secure with metal stakes through web strap loops.

Insert Rear Awning Pole

Insert rear awning pole through rainfly sleeve above back window into grommets.

Tie and Secure Guylines

Tie guylines through loops on rainfly web straps and stretch taut with stakes.

Tent Features and Storage

Electrical Cord Access

Use UL approved outdoor cords through the access panel in the lower front corner.

Cooler Access

Utilize the smaller zippered opening at the side for ventilation and cooler access.

Storage Preparation

Place poles and stakes in storage bag; ensure tent is clean and dry before storing.

Folding and Rolling

Neatly fold tent to width of pole bag, roll tightly, and place in carry case.

Important Usage Tips

Manage condensation, dry tent thoroughly, do not leave poles telescoped, avoid UV damage.