Coleman Outsider 13 x 11 - User Manual

Connect Frame to Tent
–Insert one end of main tent pole
onto pin, of pin & ring system, at
tent corner. (illus. 4)
–Go to opposite end of pole and
gradually apply pressure to the pole
forming an arch until you are able to
insert the pin into the pole.
–Repeat for second pole.
13x11 Outsider
™
Tent
1
Layout & Positioning
of Tent, Pole Assembly
–Layout and position tent with door
facing desired direction. (illus. 1)
–Unzip door.
–Stake down tent corners, and tent
sides using the rings at the end of the
stake loops and the side stake loops.
(illus 2) Keep the floor taut.
–Assemble frame poles by interlocking
shock-corded poles. This will make two
long poles.
–Insert the poles diagonally into pole
sleeves.The center of the poles should
cross forming an “X” in the middle of
tent. (illus. 1)
–Fasten frame tie on top of tent over
both poles. (illus. 1), (illus. 3)
2
When You Are Ready To Set Up
Your Tent
–Select a level campsite clear of rocks,
branches and other hard or sharp objects.
–Do not set up your tent under trees.
–For best results in windy conditions, do not
position the door of tent into the wind.
–See owners manual for more tips.
Rainfly
Pole
Rainfly Part No. 9261-833
Main Tent
Poles
POLE ASSEMBLY PARTS
Assembled poles
inserted through
pole sleeves
Frame tie
Instructions apply to Part Number 9261A131
illus. 1
illus. 2 Tent stake
through ring
illus.4
Insert pole tip onto
pin & ring
Tent frame
set-up
illus. 3
Frame tie
Part No. 9261-831
Part No. 9261-832

Summary

Tent Setup and Preparation

Preparation Before Setup

Select a level campsite, avoid trees, position tent door away from wind.

Pole Assembly Parts Identification

Identifies Main Tent Poles (Part No. 9261-831) and Rainfly Pole (Part No. 9261-832).

Layout & Positioning of Tent, Pole Assembly

Tent Layout and Pole Interlocking

Layout tent, stake corners, assemble poles by interlocking shock-corded poles into an 'X'.

Connect Frame to Tent

Attaching Main Tent Poles

Insert pole ends onto pin & ring system, forming an arch until pins engage.

Attach Tent to Frame Using Frame Clips

Securing Tent with Frame Clips

Attach frame clips along tent edges to frame poles and stake out door mat.

Attach Rainfly

Rainfly Pole Assembly and Attachment

Assemble rainfly poles, drape rainfly, connect loops, and secure with attachments.

Guylines and Tent Stakes

Stake out tent with 2 side and 4 corner guylines for stability.

Important Usage Information

Tent Care and Maintenance Tips

Tips on condensation, drying, storage, seam sealing, and UV exposure.

Flammability Warning

Keep flame and heat sources away from tent fabric; it meets flammability requirements.

Coleman Outsider 13 x 11 Specifications