QuickBed
®
with Wrap ‘N’ Roll™
Instructions
(continued)
Storage Steps
1. Deflate Airbed (Step 1)
(Leaving the Double Lock
TM
Valve
open while rolling will help remove
any remaining air for more compact
storage.)
2. Fold bed as shown. (Step 2)
3. Roll up the Airbed toward the
storage flap. (Step 3)
4. Wrap storage flap around rolled bed
and tie ends to secure. (Step 4)
Sheet Clip Instructions
(applicable models only)
1. Lift up on tab to open clip and insert the edge of
sheet. (Fig. 1)
2. Insert tab into slot and push down to close. (Fig. 2)
Wrap ’N’ Roll
TM
Storage System
Sheet
Fig. 2
Slot
Sheet
Fig. 1
Tab
Please call or write us with any comments or questions.
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, KS 67219 U.S.A.
1-800-835-3278 • TDD: 1-316-832-8707 • www.coleman.com
Sunbeam Corporation (Canada) Limited • DBA Jarden Consumer Solutions • 20B Hereford Street • Brampton, ON L6Y 0M1
1 800 387-6161
©2009 The Coleman Company, Inc. All rights reserved. Made in China.
The Coleman Company, Inc., a Jarden Corporation company (NYSE:JAH)
Coleman
®
, QuickBed
®
, , and are registered trademarks
and QuickPump™, Double Lock™, and Wrap ‘N’ Roll™ are trademarks of The Coleman Company, Inc.
To Previous Page
Loading...
Need help?
General
