Raise Tent
–Insert the curved end of the Upright
Pole onto one end of the Ridge Pole.
Repeat for all poles.
–Raise the Upright pole connected to
the Ridge Pole until you are able insert
Squeeze Pin at the corner of the tent
into bottom of Upright Pole. (works
best with 2 people) (illus. 3)
–Repeat for other poles
Vacationer
™
Cabin Tent 13’x9
1
Layout & Positioning
of Tent, Pole Assembly
–Layout and position tent with doors
facing desired direction. (illus. 1)
–Unzip doors
–Stake down tent corners. Insert stake
through the ring at the end of the stake
loops. Keep the floor taut.
–Assemble Ridge Poles and Upright
Poles by interlocking shock-corded
sections. This will make two curved poles
and four straight poles with one end curved
–Insert the Curved Ridge poles diagonally
into the Pole Sleeves.
The center of the poles should cross
forming an “X” in the middle of tent. (illus. 1)
2
When You Are Ready To Set
Up Your Tent
–Select a level campsite clear of
rocks, branches and other hard
or sharp objects.
–Do not set up your tent under trees.
–For best results in windy conditions,
position the door of tent into
the wind.
–See owners manual for more tips.
U Shaped Rainfly
Poles
Part No. 9271-108
Rainfly Pole
Part No. 9271-102
Ridge Poles
POLE ASSEMBLY PARTS
Assembled
poles
inserted
through
pole
sleeves
Instructions apply to Part Number 9271-139
illus. 1
Part No. 9271-106
Rainfly
Part No. 9271-101
illus. 3
Tent in upright
position with
poles on the
pins located at
the corners
Upright
Pole
illus. 2
Insert Squeeze
Pin into pole
Upright Poles
Part No. 9271-107
To Next Page
Need help?
General