OpInstructions_En.fm
3
2 Important warnings
Before installing and operating the Collamat 2600 read the following safety
instructions:
The labeler C2600 is exclusively determinated for labelling goods.
The installation of a Collamat 2600 has to be done by a trained specialist.
For this you have to consider the national specific regulations of.
• prevention of accidents
• mechanical stability
• construction of electrical and mechanical systems
• noise suppression
Take notice of the technical data of the Collamat 2600. Especially the envi-
ronment conditions must be observed.
The operation of the Collamat 2600 must be done by trained personnel.
In case of non-authorized modifica- tions, guarantee will fall.
Before connecting non-standard products, ask your competent technical sup-
porter.
3 Danger indications
The safety symbols and danger advices on the Collamat 2600 and in this ma-
nual must strictly be observed.
Before connecting or disconnecting the labeler C2600 it must be switched off.
The labeler C2600 may only be opened by authorized personnel.
It exists danger of pinching hair, jewelry, ties, clothes etc. into the traction
unit.
It exists danger of injury by cutting in the area of the paperweb.
It exists danger of injury in the area of the dancers of the unwinder of the
Collamat 2600.
To operate the labeler the operating personnel must keep to a safe place to
prevent injury by the products being labeled.
To Next Page
Loading...
