Columbia Summit - Seat and Seat Belt Adjustments

If any problems are found, Do not operate vehicle until repairs are made. Failure to make necessary
repairs could result in fire, severe personal injury, property damage or death. Consult your local Columbia
Dealer for professional service.
3.3 SEATS AND SEAT BELTS
NOTICE: Adjust seat before driving. After adjustment, make sure seat is secure.
Adjusting Seat
Adjust driver’s seat to allow easy operation of pedals, steering wheel and driver
controls on dashboard.
B
F
igure 3.3.1 is the driver’s seat. To adjust seat position, move the handle (A)
sideways and select seat position. To access batteries, adjust the seat fully forward,
then lift release lever (B).
A
Figure 3.3.1
If equip
ped with non-adjustable seating, the seats may still be adjusted by re-
mounting the seats at the mounting plate. Remove the four mounting bolts,
select the preferred seating arrangement using AFT, MID or FORE position
(Figure 3-2), and reinstall bolts.
T
ilt seat forward for access to batteries.
Figure 3.3.2
Seat Belts
Seat b
elts are self-adjusting. When attaching the seat belt, ensure that you are leaning back against the seat. The
chest strap should be as close as possible, without restricting the neck. The abdominal strap should be placed flat
against the thighs and abdomen.
See Figure 3.3.3. To fasten the seat belt, pull out the belt slowly and without pause, push buckle into lock (C) until
you hear a light click. If the belt binds when pulling it out, release the belt and pull out again.
To unfasten the seat belt, push on the red button (D) and release the buckle from the lock.
When the belt is not in use, the belt buckle must be positioned near the wall mounting clip (E) with the adjustable clip
(F). When leaving the vehicle, make sure belt is in proper position to avoid belt jamming in the door.
3-1
F
E
D
C
Figure 3.3.3
2012 Summit
3-2