Columbus Instruments Exer 3/6 Manual

4
Chapter 2 - Installation
Unpacking System
Inspect all equipment in shipment. If there is damage contact Columbus Instruments immediately. The
Eco 3/6 Treadmill will be about 90% assembled.
Assembly
1. Install the inclination rod by pushing it up through the hole in the front panel of the treadmill. The
20” long rod will have five holes spaced equally apart and the bottom will have a pin placed in it.
This pin should be at the bottom of the treadmill and when installed correctly will be set to 0
degrees.

Columbus Instruments Exer 3/6 Specifications

General

Brand	Columbus Instruments
Model	Exer 3/6
Category	Treadmill
Language	English