What to do if Columbus Instruments Treadmill belt does not turn?
If the treadmill belt isn't turning, there are several things you can check. First, make sure the belt speed is set to 06.0 M/M or higher. Ensure that the 'RUN/STOP' switch is in the 'RUN' position and that the motor cable is securely connected. If the belt is jammed to one side of the drive shaft, adjust the belt tension and manually turn the belt to loosen it.
Why is my Columbus Instruments Exer 3/6 Treadmill exercise belt pulling to one side?
If the exercise belt is pulling to one side of the drive shaft, the belt tension is likely unequal. Readjust the belt tension to correct this issue.
General| Running Surface | 18 x 48 in (46 x 122 cm) |
|---|---|
| Speed | 0.5 - 15 mph (0.8 - 24 kmph) |
| Elevation | 0 - 25% |
| User Weight Capacity | 400 lbs (181 kg) |
| Speed Range | 0.5 - 15 mph (0.8 - 24 kmph) |
| Incline Range | 0 - 25% |
| Belt Size | 18 x 48 in (46 x 122 cm) |
| Control | Computer Interface |
| Data Output | RS232 |
| Shock Grid | Optional |
| Stimulus Grid | Optional |
To Next Page
