1 x CI-Bus Hub or CI-Bus Switch Mini
1 x USB cable, 2m (6ft), A-B
1 x CI-Bus communication cable, 2m (6ft) (CAT5 network cable, 8p8c (RJ45), ethernet)
Treadmill Controller with AC power cord
1 x Motor Cable, 2m (6ft), 6-circuit, plug-plug
1 x Shocker Cable, 1.8m (6ft), 15-pin
1 x Calibration Wand
1 x Instruction Manual
1 x Treadmill Software Flash Drive (if using with Oxymax)
1 x Exer 3/6 Treadmill (shown with optional shock grid)
1 x Treadmill Lid
1 x Feces Tray
1 x Package of lane dividers: 5 opaque and 2 clear dividers
1 x Inclination Rod, 51cm (20in) with spring pin
2 x Thumbnuts for securing the treadmill lid
1 x 7/16in open-end wrench for adjusting the tension of the treadmill belt
2.2 Assembly
You may need the following tools for assembling the system:
To Next Page
Loading...
