Com G-95 - Page 17

13
Menu
#
Menu
Name
Description
Secondary
Menu
Notes
Narrow
Band
12.5 kHz
8
ABR
Unused Setting
--
--
9
Beep
Keypad audible tone
On/Off
Turn On/ Off keypad tone
10 R-DCS
Receive - Analog Tone
Squelch
D023N >
D754I
Squelch opens when proper DCS
code is detected
Off
No DCS code required
11 R-CTCS
Receive - Analog Tone
Squelch
67.0 >
254.1 Hz
Squelch opens when proper CTCSS
tone is detected
Off
No CTCSS tone required
12 T-DCS Transmit - DCS Code
D023N >
D754I
Transmits specified code
Off
No DCS codes transmitted
13 T-CTCS Transmit - CTCSS Code
67.0 >
254.1 Hz
Transmits specified code
Off
No CTCSS codes transmitted
14 DTMFST
Determines when DTMF
codes are heard through
speaker
Off
No DTMF tone heard
DS-ST
Only manually keyed DTMF codes
are heard
ANI-ST
Only automatically keyed DTMF
codes are heard
DT-ANI
All DTMF codes are heard
15 BCL Busy Channel Lockout
On
Prevents transmit if active signal on
the channel
Off
No lockout
16 SC-ADD Add Scan Channel
On
Add channel to scan list
Off
Remove channel from scan list
17 SC-REV Scan Resume Method
TO
(Time Operations) Scan stops when
a signal is detected the scan
resumes after approximately 5
seconds (even if the channel is still
active).
CO
(Carrier Operation) Scan stops when
a signal is detected. Scan resumes
when signal disappears
SE
(Search Operation) Scan stops when
signal is detected. Scanning will not
resume.
18 OPTSIG Optional Signaling
Off
No Optional signaling
DTMF
DTMF signaling selected
2 Tone
2 Tone signaling selected
5 Tone
5 Tone signaling selected