Events specification Protection
type
Information on binary
output available (See list
of Binary outputs)
Description
typically after downloading
new firmware or changing of
the parameter. The controller
stays in INIT mode. Check all
parameters, write at least one
new parameter.
Vgen <, > SD YES The generator voltage is out of
limits given by
Gen <V and
Gen >V setpoints.
Vgen unbl SD NO The generator voltage is
unbalanced more than the
value of
Volt unbal setpoint.
Fgen <,> SD YES The generator frequency is out
of limits given by
Gen >f and
Gen <f setpoints.
Igen unbl SD NO The generator current is
unbalanced.
Overload SD YES The load is greater than the
value given by
Overload
setpoint.
Overspeed SD YES The protection comes active if
the speed is greater than
Overspeed setpoint.
Underspeed SD YES During starting of the engine
when the RPM reache the
value of
Start RPM setpoint
the starter is switched off and
the speed of the engine can
drop under
Start RPM again.
Than the Underspeed
protection comes active.
EmergencyStop SD NO If the input Emergency stop is
opened shutdown is
immediately activated.
PickupFault SD NO Failure of magnetic pick-up
sensor for speed
measurement.
Stop fail SD YES Gen-set stop failed.
WrnServiceTime WRN NO The period for servicing is set
by the
NextServTime setpoint.
The protection comes active if
the running hours of the
engine reach this value.
ChrgAlternFail WRN YES Failure of alternator for
charging the battery.
SprinklActive WRN NO The protection is active if the
output
Sprinkler is closed.
*Wrn RA15 fail WRN NO Warning alarm in case of lost
connection to IGL-RA15
module.
*Sd IOM fail SD NO Shutdown alarm in case of lost
connection to IG-IOM/IGS-
PTM module.
Wrn ECU Alarm WRN NO ECU alarm list is not empty
InteliLite – MRS10/11/15/16, SW version 2.2, ©ComAp – November 2004 55
IL-MRS-2.2.pdf
To Next Page
Loading...
Need help?
General
