To Next PageTo Next Page
Need help?Do you have a question about the ComAp intelilite nt amf20 and is the answer not in the manual?
General| Protection Class | IP20 |
|---|---|
| Front Panel Protection | IP65 |
| Humidity | 95% non-condensing |
| Display | LCD with backlight |
| Communication Ports | RS232, RS485 |
| Supported Protocols | Modbus RTU, Modbus TCP/IP |
| Digital Outputs | 4 |
| Relay Outputs | 6 |
Outlines the manual's scope, target users, and content overview.
Crucial safety advice for installation and maintenance procedures.
Key warnings and common symbols used throughout the document.
Notes on compatibility between software and hardware versions.
Explains the InteliLiteNT AMF20/25 controller's features and capabilities.
Lists all accessories and modules included with the controller.
Step-by-step guide for installing the RS232 communication card.
Diagram showing controller terminals and their functions.
Explanation of buttons, indicators, and display on the front panel.
Guidelines for physically mounting the controller in an enclosure.
Specifies physical dimensions and required panel cutout size.
Shows essential wiring for AMF applications.
Wiring configurations for contactors and ATS systems.
Instructions for setting up two gen-sets in a mutual standby configuration.
Covers controller installation, wiring, grounding, and power supply.
How to connect and configure the magnetic pick-up speed sensor.
Details on current transformer connections and CT location.
Setting up and connecting analog sensors for various measurements.
Best practices for setting up CAN bus and RS485 networks.
Rules for connecting modules via CAN bus.
Details on default and programmable binary inputs.
Explains default and programmable binary outputs.
Procedures for password setup and essential basic parameters.
Configuration of engine and generator operating parameters.
Setup for engine and generator protection parameters.
Configuration of Automatic Mains Failure functionality.
Settings for serial communication ports and modem connections.
Configuration for Ethernet and GPRS modules for remote access.
Setup for AirGate service and SMS/Email notifications.
Detailed description of controller operating modes and their functions.
How to use TEST mode and timing relationships for breakers.
Overview of available alarms and their management.
Engine states, conditions, and history file recording.
Accessing controller information via Init Screens.
Options for selecting USER or ENGINEER interface.
Using LiteEdit for configuration, monitoring, and data logging.
Direct cable, modem, and internet connection methods.
Explanation of Modbus protocol selection and communication objects.
Table mapping setpoints to Modbus communication objects.
Summary of controller's input and output capabilities.
List of generator protections with ANSI codes.
Electrical specifications and environmental operating limits.
Technical details for optional communication and I/O modules.
