InteliLite
NT
– AMF20/25, SW version 2.2, ©ComAp – September 2014 71
IL-NT-AMF-2.2-Reference Guide.pdf
IBLite IP Addr [-]
If DHCP is DISABLED this setpoint is used to adjust the IP address of the ethernet interface of the
controller. Ask your IT specialist for help with this setting.
If DHCP is ENABLED this setpoint is used to display the IP address, which has been assigned by the
DHCP server.
IBLite NetMask [-]
If DHCP is DISABLED this setpoint is used to adjust the IP address of the ethernet interface of the
controller. Ask your IT specialist for help with this setting.
If DHCP is ENABLED this setpoint is used to display the IP address, which has been assigned by the
DHCP server.
IBLite GateIP [-]
If DHCP is DISABLED this setpoint is used to adjust the IP address of the gateway of the network
segment where the controller is connected.
If DHCP is ENABLED this setpoint is used to display the gateway IP address which has been
assigned by the DHCP server.
A gateway is a device which connects the respective segment with the other segments and/or
Internet.
IBLite DHCP [ENABLED/DISABLED]
The setpoint is used to select the method how the ethernet connection
is adjusted.
DISABLED:
The ethernet connection is adjusted fixedly according to the setpoints
IP Addr, NetMask, GateIP, DNS IP Address.
This method should be used for classic ethernet or Internet connection. When this type of connection
is opening the controller is specified by its IP address. That means it would be inconvenient if the IP
address were not fixed (static).
ENABLED:
The ethernet connection settings is obtained automatically from the DHCP
server. The obtained settings is then copied to the related setpoints.
If the process of obtaining the settings from DHCP server is not successful
the value 000.000.000.000 is copied to the setpoint IP address and the
module continues trying to obtain the settings.
ComAp Port [0 - 65535]
This setpoint is used to adjust the port number, which is used for ethernet connection to a PC with any
of ComAp PC program (i.e. InteliLIte, InteliMonitor). This setpoint should be adjusted to 23, which is
the default port used by all ComAp PC programs. A different value should be used only in special
situations as e.g. sharing one public IP address among many controllers or to overcome a firewall
restrictions.
APN Name [-]
Name of APN access point for GPRS network provided by GSM/GPRS operator.
APN User Name [-]
User name for APN access point provided by GSM/GPRS operator.
APN User Pass [-]
User password for APN access point provided by GSM/GPRS operator.
To Next Page
Loading...
Need help?
General
