NPU, SW Version 1.8, ©ComAp, September 2003
NPU-1.8r2.PDF 18
Default setting
No. Quantity (parameter) Default
B1 Failure time signaling
(red LED’s flashing time)
2880 min
B2 Display switch off time 10 min
B3 Relay RE1, RE4 switch off time 5 s
B4 Relay RE2 switch off time 5 s
B5 Relay RE3 switch off time
for vector shift protection
2,5 s
B6 Max. vector shift in L1, L2, L3 (from
manual reset)
B7 Angle between L1 and L2
B8 Angle between L2 and L3
B9 Display and LED’s brightness 7
B10 Software release
B11 Display and LED’s test
To Next Page
Loading...
Need help?
General
