When youcheck your telephone number in memory 1-20th, the number with an * behind means it
had O4 control function
3.2) Inactive the number for control O4
MEN→ *→10→#→phone number( 1-20) → ENTER
10 ~ Inactive the number for control O4
For example:
MEN→ *→10→#→11→ ENTER
this command means the 11th alarm number inactive; cannot support call back control O4
MEN→ *→10→#→3→ ENTER
this command means the 3nd alarm number inactive; cannot support call back control O4
17, Setup telephone remote control
When you received alarm calling from dialer you can press # automatic into remote monitoring
site and two-way talking via phone, Hang up end for operation (This feature is only for dial by
GSM)
authorized number can call back after 5 seconds ring tone and input password press password with
#(default password is 1234# )automatic into two-way talking via phone, and press * into
monitoring site
(This feature is only for dial by GSM). Hang up end for operation.
1) Active the number for call back remote monitoring
MEN→ *→12→#→phone number (1-20) → ENTER
12~ active the number for remote monitoring
For example:
MEN→ *→12→#→3 → ENTER
this command means the 3rd alarm numberactive can call back automatic into monitoring site and
two way talking
When youcheck your telephone number in memory 1-20th, the number with an # behind means it
had remote monitoring function
2) Inactive the number for call back remote monitoring
MEN→ *→10→#→phone number (1-20) → ENTER
To Next Page
Loading...
Need help?
General
