10~inactive the number for remote monitoring
For example:
MEN→ *→10→#→7 → ENTER
this command means the 7th alarm number inactive cannotcall back automatic into monitoring site
and two way talking
18. Setup telephone remote control
When you received alarm calling from dialer, after playback voice record, you can press #
automatic into remote monitoring site and two way talking viaphone, hang up end for
operation(This feature is only for dial by GSM)
Authorized number can call back after 5 seconds ring tone antomatic into remote monitoring side
and two way talking via phone(This feature is only for dial by GSM) Hnag up end for operation
19, Alarm Status of SIREN:
At the time of dialing after every playback of voice message if siren continues, dialer will sound 3
bip remind user, and if siren stops, dialer will sound one bip for remind of user of the alarm status.
20,Re-start dialer
In case if the dialer operation error, press* button for 5 second dialer will be off and on In this
way, all of phone numbers and message will be deleted and user can be restart to program the
dialer again
21, Forget Password
1. Disconnect the power of dialer and wait moment
2. Press 0 button for several seconds and connect the power of dialer.
3. After showed RESET USER CODE on LCD, release 0 button.
4. Default user cod is: 1234
22, Reset-Delete all of the memories and message and SMS
1. Disconnect the power of dialer.
2. Press ENTER button for several seconds
3. Connected the power of device
4. After showed RESET on LCD, release ENTER button.
In this way, all of phone numbers,SMS and message will be deleted and the dialer settings will be
reset to default setting.
To Next Page
Loading...
Need help?
General
