Select “network setup”.
DHCP: choose to enable to obtain IP address automatically. "☑" means enabled ，"□" means
disabled
Cloud (P2P)：after connecting internet , click“☑ Cloud (P2P)” to gain a ID , which can be used in IP
remote monitoring in ESeenet network server
IP address：the IP address must be unique and cannot be in conflict with the host or workstation on
the same network segment
Subnet mask：subnet for the network segment.
Gateway： need to set the gateway address to achieve communication between the different
network segments.
MAC address：showing the device's MAC address
Preferred DNS：DNS IP address
Web port：port number IE browser visit, default port is "80"
PPPOE
Start using：“☑ PPPOE” means to start up PPPOE dial-up. “□” means not to start up
Username：input the user name of ISP into edit box
Password：input the password of ISP into edit box
After the page setup is completed, click '"Ok" to save the changes; click "Cancel ", non-save.
DDNS
Automatic analytical function of dynamic domain name, supported Comelit DNS, etc. To use Comelit
DNS see the last page of this manual.
In the "network setup" menu, click " DDNS "
Start using：“☑”means DDNS dynamic domain services start using: “□”means not to start up.
Select the right network server and input user name, password and domain
System logout
In the main menu, click "System logout", popup setting interface
Logout: apply for logging users. After logout, if you want to use the device again, need to login
again
Reboot: it will reboot after "OK".
Shutdown: shutdown the NVR
To Next Page
