Comet Premium Series - Steam Cleaning

in the OFF position
• Make sure the switch P1 is in the OFF position
• Start the detergent injection pump with switch P:
(I) detergent
• To start the delivery, press lever L3.
• Activate switch L1:
• To select the suction power (from level 1 to
level 4), press the remote suction button L1
on the handgrip at short intervals; the se-
lected suction power level LED indicator will
light up. It is possible to change the power
level both when the suction is on and o. To
switch the vacuum on and o, hold down
the remote suction button L1 for about two
seconds.
It is possible to combine the DETERGENT INJECTION
AND SUCTION functions described above to
perform the washing and suction cycles at the
same time.
STEAM CLEANING
• Fit the most suitable accessory in the handle
of the exible hose L.
• Connect the device to a suitable electrical
outlet.
• Start vacuuming by pressing main switch B.
Only model DSG-CAR 3 EXVF:
• Selection switch P1 to the steam position
(I).
• Press lever L3 for steam outow.
• Turn on the steam system using switch E and
wait until “steam ready” light D lights up.
• For the outow of the steam, press the lever
L3. The rst amount of steam will come out
with water condensation; direct the jet to
one side or onto a cloth.
• Pre-select the amount of steam using the
knob F located on the appliance. The gauge
R indicates the pressure inside the boiler.
• To steam and vacuum simultaneously: it
is possible to use the above-mentioned
steamcleaning functions together.
• press the suction button L1
Only model DSG-CAR 3 EXVF
(FOAM):
• To select the suction power (from level 1 to
level 4), press the remote suction button L1
on the handgrip at short intervals; the se-
lected suction power level LED indicator will
light up. It is possible to change the power
level both when the suction is on and o. To
switch the vacuum on and o, hold down
the remote suction button L1 for about two
seconds.
• When work is nished, release the steam le-
ver L3 a few moments prior to switching o
the suction motor L1. This will allow the suc-
tion ducts to recover the humidity.
STEAM CLEANING + INJECTION HOT WATER OR
DETERGENT
• Fit the most suitable accessory in the handle
of the exible hose L.
• Connect the device to a suitable electrical
outlet.
• Start vacuuming by pressing main switch B.
• Turn on the steam system using switch E and
wait until “steam ready” light D lights up.
Only model DSG-CAR 3 EXVF:
• Selection switch P1 to the steam position
(I).
• Start injection pump by selection switch P :
H2O (II) hot water or
(I)detergent.
• To help the primer of the injection pump,
turn the steamtap F o .
• Press thelever L3
• Pre-select the amount of steam using the
knob F located on the appliance. The gauge
R indicates the pressure inside the boiler.
• To steam and vacuum simultaneously: it
is possible to use the above-mentioned
steamcleaning functions together.
• press the suction button L1
EN
22