Comet XTREME - Safety Devices

21
IDENTIFICATION OF COMPONENTS
Refer to Figures 1 to 5:
1. ON/OFF Master switch
2. Handle
3. Lance support
4. Warning plates. Inform on residual risks and PPE
to be used
5. Identication plate. Indicates the serial number,
guaranteed sound power value (incompliance
with Directive 2000/14/EC) and main technical
characteristics
6. Power cable
7. Delivery hose/power cable support
8. Pressure adjustment knob
13. Pressure indicator
14. Oil plug with vent and dipstick
(1001-1251-1501)
16. Water outlet tting
17. Water inlet tting
18. Water inlet lter
19. Castor wheel (1001-1251-1501)
20. Wheel brake (1001-1251-1501)
21. START push button
22. Spray gun lever
23. Spray gun lever safety stop
24. Spray gun
25. Water inlet hose-end tting
26. Gasket for water inlet hose-end tting
(1001-1251-1501)
27. Water inlet lter cartridge
29. Lance hose
30. Nozzle holder head
31. Nozzle cleaning pin
32. Double barrel lance knob (1001-1251-1501)
33. Double barrel lance hose (1001-1251-1501)
34. Double barrel nozzle-holder head
(1001-1251-1501)
35. High pressure hose
36. High pressure hose quickt coupling
40. Emergency push button (XTREME)
41. Relief valve (XTREME)
42. STOP push button (XTREME)
43. Mains voltage LED
47. Lifting point
48. Thermostatic valve (XTREME)
49. Hour counter (XTREME)
50. Oil sight indicator
51. Water inlet lter cup
52. Water inlet lter ring nut
53. Water inlet lter knob
55. Spray gun (1001-1251-1501)
59. Spray gun quickt coupling ring nut
(1001-1251-1501)
60. Lance hose adjustable handle (XTREME)
62. High pressure hose sleeve
63. Water inlet lter clamp
65. Self-cleaning lter water outlet
66. Oil plug with vent (XTREME)
SAFETY DEVICES
• Automatically (1001-1251-1501) or manually (XTREME) resettable ampere cut-out protection.
These devices stop high pressure cleaner operation in the event of excessive power absorption.
In this case, proceed as follows:
• Automatically resettable ampere cut-out protection (1001-1251-1501)
- move the master switch (1) to “0” position and remove the plug from the power socket;
- press the spray gun lever (22), so as to release any residual pressure;
- wait 10÷15 minutes for the high pressure cleaner to cool down;
- make sure the instructions for connection to the power supply are complied with (refer to the
Instruction manual – Safety precautions), with special reference to the extension used;
- t the plug back in the socket and repeat the start procedure described in the paragraph “Operation”.
Manually resettable ampere cut-out protection (XTREME)
- move the master switch (1) to “0” position and remove the plug from the power socket;
EN