V. Service and Maintenance
1. Readjustments, alterations and repairs
1) Do not disassemble, repair or modify the device without authorization, you will void any warranty on the product.
User manuel
-22
2) The manufacturer is only responsible for the safety and performance of the TENS and Muscle Stimulator when
readjustments, alterations and repairs are carried out by authorized individuals and when the TENS and Muscle Stimulator is
used in accordance with the user instructions.
3) Qualified technicians who are familiar with the technical features of the device have been provided with circuit diagrams,
PCB drawings, component lists and setting instructions by th
e manufacturer.
2. Cleaning and maintenance
A. For the main unit:
1) To keep the controller clean, use a soft and dry cloth for dust or a soft damp cloth for any dirt and smudges. Do not use any
cleaning solutions to clean the controller and its pads.
2) Do not use or store the device where there are magnetic fields or electric waves (near TV set or speakers).
3) Do not place the devices in areas of high temperature, high humidity, or under direct sunlight.
4) Keep the device out of reac
h of children.
5) All worn accessories should be disposed of according to your local regulations.
B. For electrode pads:
* Refer to the user manual of the pads manufacturer (K152648 & K181234), or reference to the following suggestions:
1) Unplug the output cord from the output jack of the controller after each use. Cover both pads with the protective film before
storage. Never fold the electrode pads.
2) Between uses, store the electrodes in the reusable bag in a shady place.
Stockroom temperature: +5°C~+27°C (41-80°F) and
humidity of 30%~80%. No need to sterilize.
3) Never apply the pads to any other surface other than your skin.
4) The life of the electrodes varies depending on skin conditions, storage, amount of use, type of stimulation, and stimulation
site.
5) When the electrodes dry out and do not stick, buy new pads compatible with TENS and Muscle Stimulator, with smallest
area of 25cm
2
.
Regards buying new pads, you can contact our local d
evice sell center, or you can contact the following electrode manufacturer,
they will tell you the local address where you can buy them. Or you can buy other 510(k) cleared electrode pads with smallest
area no less than 25cm
2
.
Warning: The electrodes are intended for single patient use only!
C. For Cables
1) Disconnect the cables from the stimulator and electrodes.
2) Do not pull on the cables; only pull on the connectors attached to the ends of the cables.
3) Store the stimulat
or with the cables in a clean, dry place.
3. Storage
Caution: Do not store in a damp area. Dampness may affect the device and cause rust.
- Normal working ambient temperature: 5°C~40°C (40-104°F)
- Normal working ambient humidity: ≤80%RH
- Store and transport ambient temperature: -20°C~55°C (4° -131° F)
- Store and transport ambient humidity: ≤93%RH
manual
To Next Page
Loading...