Comfier AS8015 - Setup and Charging Procedures; Connecting Electrode Pads; Battery Charging Instructions

User manuel
8
-22
best effect but still feel comfortable.
*Timer
Press “T” button or click timer icon to change treatment time among 10, 20, 30, 40, 50, and 60 minutes. After the time runs out,
the device will turn off automatically.
▲Note: If you change programs during the course of a therapy session, the treatment time will not reset unless you manually
reset it by performing the steps described above.
*Lock Screen
Press lock key
“ ”
to lock the screen, and the lock icon “ ” will appear at the top of the LCD. Press lock key
“ ”
again
or click lock icon “
” to unlock the screen, and the lock icon disappears.
*Battery power
The LCD displays battery power through 4 black squares, and each square corresponds to 1/4 battery power level. When the
battery is too low, the battery icon shows “
” and flickers, which indicates that the battery needs to be charged. During
charging, the icon runs up and down. Full bars means full battery level.
C. Connection of the electrode pads
1) The TENS and Muscle Stimulator offers 2 types of electrode cable: snap button type and lead wire type. Choose one or two
electrode cable and output ports, connect the electrode cables with socket to the output ports at the bottom of the unit.
2) Connect the snap button type electrode cables wit
h snap button type electrode pads,and connect lead wire type electrode
cables with lead wire type electrode pads before applying them to the Skin.
3) Remove the protective plastic shields from the electrode pads before placing the pads onto your skin.
Warning: To avoid an electrical short, never put two electrode pads together.
5. Charging the Battery
1) The Lithium battery can be recharged through both AC adaptor and computer USB input.
2) When the battery is low and the LCD screen blinks, it indicates that the battery needs to charge. Turn off the unit.
3) Connect the unit and the charger with USB extension cord. Plug ch
arger into any power outlet, the LCD shows that it is
charging and the bars in power symbol will run up and down. The charging process will last approximately 2-3 hours. When
charging is finished, the LCD will show a full battery cell.
4) The battery should be charged for 10 hours or so before first use.
Output A
Output B
manual