EasyManua.ls Logo

Comfort Zone CZ16W Series - User Manual

Comfort Zone CZ16W Series
4 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Save These Instructions
www.comfortzoneproducts.com
CZ16W Series
Features:
3 Speed Settings
Adjustable Vertical Tilt
Rotary Dial Speed
Pull-String Speed Control
Pull-String Oscillation Control
All Metal Safety Grilles
120V A.C. / 60 Hz.
Wall Mount Oscillating Fan
Question and Answer IconNeed help?

Do you have a question about the Comfort Zone CZ16W Series and is the answer not in the manual?

Summary

Intended Use and Safety Warnings

Intended Use

Product is for indoor residential and office use only, not industrial. Use with adequate electrical wiring.

General Safety Warnings

Includes warnings for shock, hot surfaces, fire hazards, and electrical shock.

Shock Hazard Warning

Use fan only in dry environments; avoid water sources like bathrooms or pools.

Hot Surfaces Warning

Do not touch the fan motor during operation to avoid burns.

Fire Hazard Warning

Keep away from flammable materials and do not block air vents to prevent fire.

Electrical Shock Hazard Warning

Do not use damaged cords/plugs. Ensure electrical system is up to code.

Prevent Electric Shock Caution

Use polarized plug correctly; ensure full insertion into grounded outlet.

Fan Usage and Operation

Fan Operation

Operate fan in upright position. Plug into 120V AC, 60Hz outlet. Ensure tight fit for plug.

Fan Connection

Plug fan directly into 120V AC, 60Hz outlet. Avoid overloading circuit by not using shared outlets.

Turning Fan On

Rotate dial to desired speed (1-LOW, 2-MEDIUM, 3-HIGH) or use pull-string control.

Turning Fan Off

Rotate switch to OFF position or use pull-string to cycle speeds and turn unit OFF.

Oscillation Control

Pull left side pull-string to start oscillation; pull again to stop oscillation.

Adjusting Fan Tilt

Tilt the fan to the desired position; the ratcheting effect should hold the angle.

Assembly Instructions

Remove Blade Cap

Twist blade cap clockwise to remove. Note: Threads are reversed; unscrewing is clockwise.

Assemble Rear Grille

Fit rear grille onto motor housing pins. Secure with locknut onto motor housing.

Install Fan Blade

Place fan blade onto motor shaft, aligning pin with slot. Secure with blade cap (tighten counter-clockwise).

Attach Front Grille

Attach front grille to rear grille using hook clip and grille clips.

Mount Fan to Wall

Secure wall bracket to wall using proper anchors. Hang fan on bracket and secure with bracket screw.

Care, Maintenance, and Fuse Replacement

Cleaning Instructions

Disconnect power before cleaning. Use damp cloth for grille; do not immerse fan or wires in water.

Maintenance

Internal motor bearings are permanently lubricated and require no additional lubrication.

Repair and Storage

Do not use if damaged. Store in original carton, coil cord to avoid damage.

Fuse Replacement

Replace blown fuse with identical 2.5 or 5.0 Amp, 125 Volt fuse. Do not pull by cord.

Limited Warranty Information

Warranty Coverage

Guaranteed against defects for one year from purchase. Return to retailer within 30 days, then to World and Main.

Warranty Exclusions

Does not cover damage from misuse, abuse, or alteration. Repairs by others are not covered.

Implied Warranties

Implied warranties of merchantability and fitness are limited to one year. State laws may vary.

Liability Limitations

Disclaims incidental or consequential damages. Some states may not allow these limitations.

Comfort Zone CZ16W Series Specifications

General IconGeneral
BrandComfort Zone
ModelCZ16W Series
CategoryFan
LanguageEnglish

Related product manuals