CTK04 ComfortNet™ Communicating Thermostat
9
I/O-CHTSTAT03 69-2688—07
MCR32935
MCR32934
WhiletheAddDevicescreenisdisplayed
on the thermostat, press and release the
CONNECTbuttononeachwirelessdevice,as
describedbelow.Accessoriesneedtobeat
least2feetawayfromthethermostatduring
thelinkingprocess.
Ifyouneedtoreturntothe"AddDevice"screentoadddeviceslater,pressMENU
andscrolldowntopressINSTALLER OPTIONS.Enterthedatecode(password)when
prompted.Thedatecodeisprintedonthebackofthethermostat;orpressMENU >
EQUIPMENT STATUStofindthedatecode.Afteryouenterthepassword,scrolldownto
press WIRELESS DEVICE MANAGER and then select ADD DEVICE.
Link optional accessories to wireless network
4
Wireless outdoor sensor
Wireless indoor sensor
Press and release CONNECT. After
a short delay the thermostat will
display "Wireless Outdoor Sensor
added" on the Add Device screen.
Press and release CONNECT.
After a short delay, the status light
will glow green for 15 seconds.
If the status light turns red, the sensor did not link with the thermostat.
Battery level indicators (when batteries are inserted)
Good: Status light flashes green for 5 seconds.
Low: Status light flashes red for 5 seconds. Use fresh batteries.
Battery level indicators (during use)
Good: Status light remains off.
Low: Battery power will be depleted in about 2 months. Thermostat displays Low
Battery warning. Status light remains off.
Critical: Battery power will be depleted in about 2–3 weeks. Status light flashes red.
Press DONE after all devices have been linked
When power is interrupted, the equipment and the RedLINK
accessories will automatically restore communication after power
resumes.
If you have both a wired and wireless outdoor sensor installed, the
thermostat displays the reading from the wireless outdoor sensor.
The thermostat can use up to 6 optional
wireless sensors.