Introduction of LaserGRBL
7
Reset button：You can click the reset button when need to pause the engraving or when there is an abnormal
situation.
0113
Return button: Click the button, the X, Y-axis will run to the mechanical origin. It is recommended that when in
large size carving, you could click the button to return to zero before the engraving.
Unlock button: After resetting, you need to click
the unlock button；
Origin button: When the button is clicked, the
current position is taken as the origin.
Preview button: When the button is clicked, the X and Y axes will be moved to the maximum square size of the
engraving pattern.
Unlock button: After resetting, you need to click
the unlock button；
Origin button: When the button is clicked, the
current position is taken as the origin.
Open Light button: Click the button and the laser will open. If there is no light, please select the light button,
right-click the edit button and adjust the power F value
Lines: The total number of lines of G code. The more
lines, the longer the engraving time will be；
To Next Page
