Troubleshooting
10
2：After the product is connected to LightBurn, it is
displayed as connected but cannot be operated.
Solutions:
Disconnect the power supply and USB cable of the product and
reconnect it;
3：After the product clicks reset, start the start button and
the product stops working and the alarm information is as
follows.
Solutions:
1：Confirm whether the cut settings editor bar
overscan has been turned on, if it is turned on click to close it；
2：If you need to set (Over scanning) during engraving, move
the X-axis to a certain distance from the limit switch and click
the set home button to start engraving.
4：The product stops and does not move after
engraving or moving a certain distance.
Solutions:
1: Check whether the USB connection is normal;
2: Enter $33=0 in the console, restart, after confirming that it is
OK, enter $33=1, $140=16 in the console
0117
To Previous Page
Loading...
Need help?
General
