Commax CMV-70M - Page 6

6
- This function is only for MODUM system.
- If the MODUM system is connected, it is automatically recognized when it boot.
Please reboot the power after installation for stable operation.
1)
Communicate with visitor
(1) Paging from a common entrance
① When a visitor page from a common entrance, the paging tone rings and the visitor’s
figure appears on the monitor.
②
Press 'Talk' button to talk to the visitor and “Door release” button to open the door.
(The door release function is enabled only when the screen is turned on.)
③ If another visitors calls from an individual entrance, the paging tone rings and press
“Monitoring” button to receive a call from the individual entrance after finishing the
communication with a common entrance.
④
Press 'Talk' button to finish the call and convert to standby mode.
(2) Paging from an individual entrance
- Same as the Single system mode.(Except interphone related information)
- The paging tone rings when it is received a paging from a common entrance or guard
station while talking with the individual entrance. Press “Guard and interphone” button
to connect after finishing communication with the individual door unit.
2) Communication with a guard
(1) Receive a call
① The paging tone rings when receive a call from guard station.
②
Press 'Talk' button to communicate.
③ When it receive any paging from an individual door camera, the paging tone rings and
press “Monitoring” button to receive a call from the individual door camera after
finishing the communication with a guard station.
④
Press 'Talk' button to finish the communication and convert to standby mode.
Use for MODUM system
6-1-2
(2) Make a call
- The following menu appears on the right-lower corner when “Guard and interphone” button is
pressed in standby mode.
- For paging “Porter”, press “Monitoring” button while the menu is displayed on the screen.
: The call is connected if PORTER receives it.
- For paging “Guard”, press
“Guard and interphone” button
while the menu is
displayed on
the screen.
: The call is connected if the
guard receives it.
-
Press 'Talk' button if you don’t
make a call.