5
1. Depress the battery lid to open and install 4 standard AA type 1.5V batteries by connect-
ing the snap-on lead to the battery terminals.
2. When you want to talk with the other party, raise the handset and press the call button,
this sends a call tone to the other station.
3. When the bell is ringing, raise the handset and speak with the other party like telephone.
4. On completion of the conversation, replace the handset.
NOTE :
1) Can control the sound of bell rings by use volume switch. As example, you may setting on
the volume switch at “L” position, volume is low but setting at “H” position, volume is high-
er.
2) If you don't want to use dry battery, you can use 6V DC adaptor(over than 200mA) as an
alternative.
3) On completion of the conversation, power is automatically cut off when the handset is
replaced in the cradle; always ensure that the handset is properly located to avoid exces-
sive battery drain.
4.
Operation
To Next Page
Loading...
Need help?
General
