5
2) Press No. 05 (05 will appear on top half of the LED screen)
1) Lift handset or press the speaker button.
4) Replace the handset or depress the speaker button again.
3) Press the station's number. (The number will appear on bottom half of the LED)
6) To cancel, repeat steps 1 to 4 without pressing the station's number.
5) The station number will flash on the botton half of the LED to indicate the assignment is completed.
3-7. Representative Answer Function
If a station is engaged the call can be diverted to another station in the same group.
3-8. Absence Indicator / Reject Function
If a station is unattended or you don't want to take the call, a message will appear on the caller's LED screen.
2) Enter your station number.
1) Lift handset or press the speaker button.
4) A line will flas on the half of LED screen. The message is now activated.
3) Replace handset or press the seaker button again.
5) To cancel the message, pick up and put down the handset.
3-9. Volume Adjust Function
Volume adjustment can only be done in the 'Standby' mode. There are three volume levels, low, mid, max.
- Ensure the unit is in 'Standby' mode.
- Press the volume button to dispaly current volume level.
- Adjust volume level by double pressing rapidly the following :
U1 ....................... low volume
U2 ....................... mid volume
U3 ....................... max volume
To Next Page
Loading...
Need help?
General
