SET-UP
OHER
8 4
4
If prefered, you can adjust
your handlebar height by
modifying the spacer stack.
To do so, unscrew and remove
the topcap. Then, untighten the
stem bolts. Remove the stem
and adjust the spacer stack
to change height.
For singlespeed bikes, check
that your chain is correctly
tensioned. You should have a
maximum vertical movement
of 1cm at the centre of the
chain line. If this is not the case,
you should tighten further by
pulling your wheel back in the
drop outs before tightening the
bolts. If you have a ne adjuster
/tightener tted, this can be
used also.
When you have nished
assembling your bike, you
can adjust your controls
and grip position.
These settings are personal,
you are free to set them to
your preference.
!
Do not remove or add
spacers to the stack.
Make sure your wheel sits straight
in the drop outs and is aligned with
your frame.
Respect the torques provided and
be sure that all the controls are
working and reachable.
SET THE HANDLEBAR HEIGHT CHAIN TENSION CONTROLS POSITION
COMMENCAL / P.22
To Next Page
Loading...
