CHAPTER
2
PREPARING TO
USE YOUR
DISK DRIVE
Before starting to use your disk drive, make sure it is in good working condition.
This includes properly connecting it to your computer, giving it a power-on and
initial checkout test, and finally the performance test using the appropriate
TEST/DEMO diskette.
CONNECTING THE DISK DRIVE
TO THE COMPUTER
One of two connector cables are required to interface the floppy to the compu-
ter. These cables can be supplied by your Commodore dealer.
1. PET-to-IEEE cable P.N 320101
Use this cable if the disk drive is to be the only (or first) IEEE device
connected to your computer.
2. IEEE-to-IEEE cable, P/N 905080
Use this cable if your disk drive is to be connected ("daisy chained") to
another peripheral device such as the Commodore Model 2022, or any
other suitable interfaced printer.
9
To Next Page
Loading...
