Commodore 2031 - Performing the Power-On Test

Follow these steps to connect the disk drive to you computer:
STEP 1. Turn power OFF to the computer.
STEP 2. Place the disk in a convenient location as close as possible to
the computer. DO NOT connect the disk drive to a power outlet at
this time (see Figure 2).
STEP 3. Connect the PET-to-IEEE cable between the IEEE-488 interface
connector on the computer and the connector on the disk drive. If
additional IEEE devices are to be connected, the IEEE-to-IEEE
cable(s) must be used.
STEP 4. Connect the disk drive power cable to an AC outlet. DO NOT turn
on power at this time.
Figure 2. Floppy Disk Hookup
PERFORMING THE POWER-ON TEST
You are now ready to proceed with the power-on part of the checkout:
STEP 1. Open the disk drive door. Ensure that there is no diskette in the
drive.
STEP 2. Turn power ON to the COMPUTER and verify that it is working
properly.
10