7
COMMON S.A. CGT-OM-18 february.2018
Table 2. Basic metrological parameters of CGT-02 meters
Q
min
minimum flow at rangeability:
HF1, HF2
emitter
constant
(approximate)
HF3 ÷ HF6
emitter
constant
(approximate)
(1) – refers to gas meters operating in HV positions, equipped with sealed bearings or a check
valve dedicated for periodic lubricant application (without piston pump and oil
container)
(2) – refers to gas meters for working pressures (p) 2 ÷ 11 MPa.
(3) – for particular gas meters the measured pressure drop value can be different by ± 5 %
from values specified in Table2.
NOTE: For gas meters equipped with all options (2 HF sensors on the turbine wheel & 2 HF
sensors on the reference wheel & 2 thermowells) the ∆p pressure drop can be
increased by 20%.