CommScope Engine 3 Model 4834 - Engine LED Indicators; Power Indicator Status

860576982
Instruction Sheet
www.commscope.com
Page 6 of 7
For the 200 VAC–250 VAC version
, the engine requires a maximum 12A of current from the branch circuit to
which it is connected when operating at full power. At minimum, a 15A branch circuit is required for a single
engine, given the standard 80% de-rating.

AC input: 200–220 VAC/12A, 50–60Hz

230 VAC-250 VAC/10A, 50–60Hz

Max power consumption: 2,200W
Note: Redwood
does not furnish any pigtails, plugs, receptacles, conduit, or flex cable.
Engine LED Indicators
The engine has a series of LEDs on the front panel to communicate the system’s status.
These LEDs provide information on the engine’s operation and the status of port communication.
Power
Indicator Status:
Power LED Indicator
Engine Status
Off
No power is delivered to the engine.
Blinking green
The engine is booting. Redwood manager software is not yet running.
Solid green
The engine is on and functioning normally.
Solid amber
The engine is experiencing a problem. Call Redwood support.