ComNav P4 Remotes Series - User Interface; Current Mode

ComNav P4 Remotes Installation & Operation Operation
Document PN 29010102 V1r1 - 19 -
User Interface
P4 Autopilot Remotes have 4 buttons and a tiller or Joystick as the user input interface. The table
below shows their functions in under different operation mode.
Button
Button Action
Operation mode
Condition
Function Result
CMD
Short Press
Normal operation
modes
REMOTE as a
repeater
Request to P4 SPU
for taking command
Double click
Start up mode and
Normal operation
modes
REMOTE as a
repeater
Initiate the
configuration menu
Click
Configuration menu
Root menu
Select current item for
editing
Click
Configuration menu
Editing a menu item
Save the item value
and go back to the
menu list
Click
Mode selection menu
REMOTE is in
command
Immediately request
a mode change
without waiting for
time out
MODE
Short press
Normal operation
modes
REMOTE is in
command
Initiate Mode
selection menu
Click
Mode selection menu
REMOTE is in
command
Move to the next
available mode
Click
Configuration menu
Root menu
Move to the previous
menu line
Click
Configuration menu
Editing a menu item
Increase the item
value
STBY
Short press
Normal operation
modes
REMOTE is in
command
Request to P4 SPU
for switching to
Standby mode
Click
Configuration menu
Root menu
Cancel / close the
menu
Click
Configuration menu
Editing a menu item
Cancel editing and go
back to the menu root
Click
Mode selection menu
REMOTE is in
command
Cancel the selected
mode (cancel the
timer) and stay in the
current mode
Lite (*)
Click
Normal operation
modes
No menu operation
Increase the LCD
brightness 1 step.
After maximum
brightness, it returns
to the lowest.
Long press
Normal operation
modes
No menu operation
Toggle between day
and night mode
Click
Configuration menu
Root menu
Move to the next
menu line
Click
Configuration menu
Editing a menu item
Decrease the value of
the menu item
Note: Required that the Config Menu can ONLY be opened in repeater / remote state.