Compak CUBE TAMP - 7.3. WHERE TO USE IT; 7.4. INSTALLATION

ORIGINAL INSTRUCTIONS | Ref.quality process 002/03 | v. 22/12/2020 | K08021H05
13
7. INSTALLATION
7.4. INSTALLATION
Before connecting the machine, check the
following:
• The characteristics on the data plate
match those of the electrical mains
network.
• The electrical connection plug
matches the socket into which it is to
be plugged.
• Ensure that the electrical power of
the facility is adequate for the power
consumed by the appliance.
• The point of connection to the
electrical mains network must
be protected with the appropriate
electrical protection device.
• The equipment must be correctly
connected to a ground connection
according to the current safety
regulations.
Height
280
11.02
mm
in
Width
166
6.53
mm
in
Depth
186
7.32
mm
in
7.3. WHERE TO USE IT
The appliance must be installed on a
solid, flat surface.
The minimum size of the
workplace, to ensure the best
performance of the device, must be at least
the following: