Compak CUBE TAMP - OPERATION; 8.1. POWER SWITCH; 8.2. FITTING THE PORTAFILTER

ORIGINAL INSTRUCTIONS | Ref. quality process 002/03 | v 22/12/2020 | K08021H05
14
8. OPERATION
8.1. POWER SWITCH
The power switch (
9
) has 2 positions:
( )
: Equipment on
: Equipment off
8.2. FITTING THE PORTAFILTER
It is essential that the portalter is perfectly
adjusted to achieve a consistent and level
tamping.
Make sure that the diameter of your
portalter matches that of your Cube Tamp’s
coffee tamp.
To adjust the support height:
Make sure the power switch (
9
)is in the
OFF position. Fig.1
Turn the wheel (
8
) clockwise to lower the
support. Fig 2
Counter-clockwise to raise it.Fig 3
Fig. 1
NOTE: The manufacturer reserves
the right to vary the components
of the machine, according to the
requirements of each market, as
well as technological advances.