Compak E6 OD - Grinder Setup and Operation

ORIGINAL INSTRUCTIONS | Ref. quality process 002/03 | v. 22/07/2015 | K06307
10
8.2.Grinderupset
Place the hopper ( ) on the grind regulator ( ) and make sure the bean trap ( )
is in the closed position. Lock the hopper ( )inplaceusingaatheadscrewdriver
to gently tighten the hopper security screw making it match to the hole at the bean
hopper collar ( ) (Fig. 2).
Remove the hopper lid ( ),llthehopperwithcoffee( ), and replace the lid on the
hopper ( ) (Fig. 3).
Plug in the grinder, and place the main power switch ( ) AUTOMATIC–OFF–MANUAL
/ I-OFF-II to position AUTOMATIC / I and open the bean trap ( ) to allow coffee to
pass into the grind chamber.
8.3.Grindadjustmentsystem
8.3.1.Parallelmicrometricalsystem
Rotate the grind regulator ( ) until reaching the grind level desired.
Rotating the grind regulator clockwise will result in a courser grind; turning the
regulatorcounterclockwisewillresultinanergrinder*(Fig. 4).
Onceyoureachthedesiredgrindingpoint,youcanxthegrindingregulation( )
using the regulation break ( ) (Fig. 5).